You’ll need to repeat this step until it is working again.
But if your tub is still draining slowly, you’ve probably missed some hair or debris. If so, you’re all done just reconnect all the parts. Test again to see if the water drains down your tub more smoothly. With any luck, the hair or debris that’s clogging your tub drain will be hooked onto the auger. When you meet resistance, start turning the hand auger clockwise while slowly withdrawing it. If so, you’ll need to feed a hand auger into the overflow hole and down into the drain. The vinegar and petroleum jelly work to (1) keep the parts from being sticky and hard to use, and (2) keep the parts protected and moving efficiently.Īfter you’ve cleaned the assembly, turn the water on and see if the tub still drains slowly. Then dry the drain assembly and smear the plunger with petroleum jelly. Now that the trip lever drain assembly has been removed, clean the linkage (see photo above right) and plunger with a toothbrush and vinegar. Then gently (but firmly) pull out the entire assembly so you can clean it with vinegar and petroleum jelly. Remove the screws on the trip lever faceplate (this is also called an overflow plate). Now, simply remove the tub drain assembly out of the overflow hole. Once done, set the plate and screws aside. Start by removing the screws holding the overflow cover plate.
BATHTUB OVERFLOW COVER WITH TRIP LEVER HOW TO
The photos will help you visualize what you’re working with and how to follow along. How Do You Clean a Trip Lever Drain?įollow along with these quick three simple steps and your trip lever tub drain will be clean in no time. The entire job shouldn’t take about 30-45 minutes. Aside from some vinegar and petroleum jelly stored in most households, you’ll also need: Replace the Trip Lever Tub Drain Assemblyįrankly, you won’t need much to do this job.
0 kommentar(er)
